Commercial Energy Efficiency | FridgeWize & Madison Energy Partner

Commercial

Your operating costs are higher than they need to be.

We reduce what your sites cost to run and extend the life of plant you would otherwise be replacing. Payback lands in 18–24 months; where the scope qualifies, incentives cover most of the capital.

Tell us about the site

Where the savings actually come from.

A day of electrical loadTotal consumption is the whole area under the load curve across the day. The single highest peak is what utilities bill as demand.The peak sets demandArea = total consumption00:0012:0024:00Illustrative daily shape. Interval data from your own meters gives the real one.

Most of a commercial bill is driven by equipment that runs continuously, so that is where the savings are. Utilities also bill a separate charge against the highest peak, which the same work tends to flatten.

Sectors

Where it adds up fastest.

Largest where cooling runs around the clock. The bigger your portfolio, the better the arithmetic.

Hotel & hospitality
You pay to condition empty rooms. Occupancy-linked control stops that, invisibly to the guest.
Warehouse & industrial
Continuous motor loads respond hardest to variable-speed retrofits — and carry the largest incentives available.
Healthcare & assisted living
Ventilation and climate run every hour and cannot be switched off. Control is the only lever, and it is a large one.
Office & retail
Rooftop units drift out of sequence and nobody notices until the bill arrives.
Grocery & supermarket
Refrigeration is your largest line and never stops. We control it without touching the sales floor.
Restaurant & QSR
Walk-ins, HVAC, and exhaust. One fixable problem, multiplied by every location you operate.
Cold storage & food processing
Compressors and fans run continuously against thermal load. Staging and defrost logic cut draw without risking product.
Convenience & fuel
Small per site, significant across the network. Built for a portfolio-wide rollout.

Before a rollout

Prove it on one site first.

We install at one location and measure against that site’s own baseline. If it misses the model, it doesn’t roll out. When it lands, we stage the portfolio and carry the incentive filings.

Funding

How the project gets paid for.1

  1. 01

    Utility incentives

    Where the scope qualifies, ratepayer-funded programs cover 60–80% of project cost. We determine what you qualify for and carry the filings through to payment.

  2. 02

    Nationwide financing

    Priced against verified savings, not equipment cost, with terms set so your monthly reduction exceeds the payment. Some programs carry 0% interest.

  3. 03

    Repaid from the savings

    Where you prefer it, the equipment is repaid out of the documented reductions rather than up front. Payment tracks measured performance.

Also available

Commercial solar and storage, EV charging and Title 24 compliance, multi-family sub-metering, and general electrical contracting — all on the same C-10 license. We lead with efficiency because it returns faster.

How an assessment works.

You get a written reduction plan: the saving available at your sites, the incentives you qualify for, and the financed position.

If the numbers don’t work at your facilities, we’ll say so.

We reply within one business day. Your details stay with us and are never sold or shared.

Notes & sources

  1. 1Incentive coverage of 60–80% reflects confirmed awards on identified qualifying scopes, chiefly FridgeWize retrofits. Coverage varies by utility territory and measure; scope outside those programs may attract limited or no incentive. Payback of 18–24 months applies either way.
  2. 2Zero-interest financing is subject to qualification and program availability.
  3. 3Post-installation consumption is measured against the established baseline and reported. Verification substantiates both the incentive claim and the financing.